Weight
Retatrutide
Metabolic
40
Amino acids
Molecular weight
Peptide
Type
Novel triple hormone receptor agonist targeting GLP-1, GIP, and glucagon receptors. Phase II trials demonstrated 24.2% weight loss at 48 weeks—the highest recorded for obesity medications.
Top researched benefits
Overview of Retatrutide
Activates GLP-1 for appetite suppression, GIP for insulin sensitivity, and glucagon for increased energy expenditure and hepatic fat oxidation.
weight loss
- Clinical trials show 17.5% weight loss at 24 weeks and 24.2% at 48 weeks.
- Continuous weight loss with no plateau at 48 weeks suggests greater long-term potential.
- Addresses obesity through appetite suppression, energy expenditure, and metabolic efficiency.
type 2 diabetes
- HbA1c reductions up to 2.16% with 82% achieving target levels below 6.5%.
- Balanced glycemic control with minimal hypoglycemia risk.
- Marked improvements in sensitivity with potential for reduced exogenous insulin requirements.
cardiovascularmetabolic
- Non-HDL cholesterol reductions up to 26.9%, triglyceride reductions up to 40.6%.
- Consistent decreases in systolic and diastolic blood pressure across trials.
- Up to 82% reduction in liver fat with normalization in 90% of participants.
Typical Dose
0.25mg starting, titrate up weekly or until effects are noticeable, then maintain dose. Do not exceed 8mgs weekly.
Frequency
Once weekly (same day each week) 0r every other day if following microdosing schedule
Cycle Duration
Continuous therapy as prescribed
Storage
Reconstituted: 2-8°C, use within 28 days
Chemical Makeup
Key benefits
Superior weight loss (24.2% at 48 weeks)
Improved glycemic control (HbA1c reduction up to 2.16%)
Enhanced cardiovascular benefits
Hepatic fat reduction (up to 82%)
Triple mechanism addresses obesity through multiple pathways
Community interest
This peptide is still gaining traction in the community.
Triple GLP-1/GIP/Glucagon Agonist | Weight Loss & Diabetes
This overview is informational and based on aggregated descriptions from studies and user reports.
Was it helpful?YesNoRetatrutide Molecular Information
View the scientifc details of Retatrutide.
40
Amino Acids
Retatrutide
His
His
Position 1
Sec
Sec
Position 2
Glu
Glu
Position 3
Gly
Gly
Position 4
Thr
Thr
Position 5
Phe
Phe
Position 6
Thr
Thr
Position 7
Ser
Ser
Position 8
Asp
Asp
Position 9
Val
Val
Position 10
Ser
Ser
Position 11
Ser
Ser
Position 12
Tyr
Tyr
Position 13
Leu
Leu
Position 14
Glu
Glu
Position 15
Gly
Gly
Position 16
Gln
Gln
Position 17
Ala
Ala
Position 18
Ala
Ala
Position 19
Lys
Lys
Position 20
Glu
Glu
Position 21
Phe
Phe
Position 22
Ile
Ile
Position 23
Ala
Ala
Position 24
Trp
Trp
Position 25
Leu
Leu
Position 26
Val
Val
Position 27
Arg
Arg
Position 28
Gly
Gly
Position 29
Arg
Arg
Position 30
Gly
Gly
Position 31
Pro
Pro
Position 32
Ser
Ser
Position 33
Ser
Ser
Position 34
Gly
Gly
Position 35
Ala
Ala
Position 36
Pro
Pro
Position 37
Pro
Pro
Position 38
Pro
Pro
Position 39
Ser
Ser
Position 40
Molecular Weight
4DaChain Length
40Amino AcidsType
PeptideRetatrutide Protocols
Weekly subcutaneous injection into abdomen, thigh, or upper arm with site rotation.
| Goal | Dosage | Frequency | Route |
|---|---|---|---|
| Starting Dose (Week 1-4) | 0.5 | 1 week range | SubQ |
| Low Maintenance (Week 4-8) | 1 | 1 week range | SubQ |
| Escalation (Week 8-12) | 2 | 1 week range | SubQ |
| Moderate (Week 12-16) | 4 | 1 week range | SubQ |
| Advanced (Week 16-20) | 8 | 1 week range | SubQ |
| Maximum Efficacy (Week 20+) | 12 | 1 week range | SubQ |
Reconstitution Instructions
Materials needed:
Steps to reconstitute
- Allow vial to reach room temperature (15-20 minutes)
- Clean vial top with alcohol swab and air dry completely
- Add calculated bacteriostatic water slowly down vial side
- Gently swirl in circular motions—avoid vigorous shaking
- Allow full dissolution (2-3 minutes); solution should be clear and colorless
- Store reconstituted solution refrigerated at 2-8°C for up to 28 days
- Inject subcutaneously; rotate sites weekly
Retatrutide Cycle
The Retatrutide Cycle section explains how long a typical cycle lasts and what to expect during each phase. Over time, your body can become less responsive with continuous use.
Taking breaks between cycles may help maintain effectiveness and support better overall results.
- Week 1-2
- Initial appetite suppression and mild GI effects as body adapts to triple hormone activation
- Week 2-4
- Noticeable food cravings reduction and portion size decrease; early weight loss (2-5%)
- Week 4-8
- Significant appetite control and steady weight loss (5-10%); improved glucose control
- Week 8-16
- Substantial weight reduction (10-18%) with enhanced energy expenditure
- Week 16-24
- Major weight loss milestone (15-22%) with cardiovascular benefits and liver fat reduction
- Week 24-48
- Maximum clinical efficacy (20-24.2%) with comprehensive metabolic improvements
Dosing tools
Retatrutide Peptide Dosage Calculator
Calculate peptide doses with our visual syringe guide.
mg
Enter the total amount of peptide in the vial in milligrams (as stated on the label).
The dose you want to inject per administration, in mcg or mg.
1,000 mcg = 1 mg
1 mL
2 mL
3 mL
5 mL
Custom
Volume of bacteriostatic water you add to reconstitute the powder. Use BAC water for preservation.
Injection Results
Based on your vial and dilution inputs.
Retatrutide
SINGLE COMPOUNDVolume per injection
0.05
mL
Concentration
10.00
mg/mL
Doses per vial
20
doses
Total injections per vial
20 injections
How it works
Based on a 10 mg Retatrutide vial diluted with 1 mL of bacteriostatic water, each 500 mcg injection equals 0.05 mL.
1mL / 100 units
5 units
0.050 mL
Reference Guide
Dosing Cycle
- Peptide
- Retatrutide
- Dosing
- 0.25mg starting, titrate up weekly or until effects are noticeable, then maintain dose. Do not exceed 8mgs weekly.
- Dosing Frequency
- Once weekly (same day each week) 0r every other day if following microdosing schedule
- Cycle Duration
- Continuous therapy as prescribed
- Storage
- Reconstituted: 2-8°C, use within 28 days
Note: Triple agonist; microdose for fewer side effects
Reconstitution Tips
- Use bacteriostatic water (BAC) — contains 0.9% benzyl alcohol for preservation
- Inject water slowly — aim down the vial wall, not directly onto powder
- Never shake — gently swirl or roll the vial until dissolved
- Store properly — refrigerate at 2-8°C after reconstitution
- Use within 28 days — most reconstituted peptides remain stable for about 4 weeks
- Keep sterile — always clean vial tops with alcohol before drawing
Peptide Interactions
Research suggestions of Retatrutide interactions with other common peptides and substances.
Healing
bpc
Longevity
BPC-157
COMPATIBLE
Safe combination; BPC-157 may provide GI protective benefits during retatrutide use.
Weight
cag
Metabolic
Cagrilintide
MONITOR
Both cause significant GI effects. Not recommended without specialist supervision.
Weight
sem
Metabolic
Semaglutide
AVOID
Do not combine—overlapping GLP-1 agonist mechanisms increase severe hypoglycemia risk.
Side effects
Avoid: Do not take Retatrutide with Semaglutide.
Monitor: Be careful when combining Retatrutide with Cagrilintide.
Contraindications
Personal or family history of medullary thyroid carcinoma
MEN2 syndrome
Severe renal impairment
Stop signs
Severe persistent nausea or vomiting preventing adequate nutrition
Signs of pancreatitis: severe abdominal pain radiating to back
Severe hypoglycemia symptoms: confusion, dizziness, sweating
Excessive weight loss (>3 lbs per week consistently or >25% total body weight)
Gallbladder problems: severe right upper abdominal pain
Bad signs
Comments
0.0
0 reviews
5
4
3
2
1
No comments yet
Be the first to share your experience. Your review helps others make more informed decisions.
Frequently asked questions
What is a peptide dosage calculator?
A peptide dosage calculator is a free tool that converts your vial size, bacteriostatic water volume, and target dose into an exact syringe draw volume. Instead of doing the reconstitution math by hand, you enter three inputs and instantly get the concentration of your solution and how many milliliters or syringeunits to draw. This calculator works for single peptide compounds and multi-peptide blends.
How do I calculate peptide dosage from a vial?
To calculate your peptide dose, divide the total peptide content of your vial in micrograms by the volume of bacteriostatic water you added in milliliters. This gives you your solution concentration in mcg/mL. Then divide your target dose by that concentration to get your draw volume. For example, a 5mg (5,000 mcg) vial reconstituted with 2mL of BAC water gives a concentration of 2,500 mcg/mL. A 250 mcg dose would require drawing 0.1mL. This calculator automates all of those steps instantly.
How much Bacteriostatic water should I add to a peptide vial?
Most people add 2mL to 3mL of bacteriostatic water per vial, but the right amount depends on the dose you want to draw and the syringe size you are using. Adding 1mL to a 5mg vial gives you a concentration of 5,000 mcg/mL, making each dose very small in volume. Adding 2mL gives you 2,500 mcg/mL, which is easier to measure on a standard insulin syringe. A general guideline is to choose a volume that puts your typical dose somewhere between 10 and 30 units on a U-100 syringe. Use the calculator above to test different water volumes and find what works for your dose.
How are peptides different from proteins?
Both are made of amino acids, but peptides are much smaller than proteins. Because of their tiny size, peptides can act like tiny messengers in the body, sending specific signals to your cells to tell them exactly what to do.
RetatrutideResearch References
Retatrutide is an extensively studied compound
Retatrutide
Retatrutide is an extensively studied compound
Phase II Obesity Trial
Landmark RCT in 338 participants showing dose-dependent weight loss; 12mg dose achieved 24.2% reduction—highest recorded for any obesity medication. NEJM.
2023
Phase II Type 2 Diabetes Study
Trial in 281 participants with type 2 diabetes: 16.9% weight loss and HbA1c reductions up to 2.16%. The Lancet.
2023
MASLD Substudy
Metabolic dysfunction-associated steatotic liver disease study: 82% liver fat reduction with normalization in >90% at highest doses. Nature Medicine.
2024
Structural Insights into Triple Agonism
Cryo-EM structures reveal simultaneous activation of GLP-1R, GIPR, and GCGR, explaining superior clinical efficacy. Cell Discovery.
2024